![assetto corsa pc macbook pro assetto corsa pc macbook pro](http://macosgaming.net/wp-content/uploads/2018/10/Assetto-Corsa.jpg)
The net effect was a terribly loud PSU fan despite having a cooler GPU core temperature. The included power supply does not have a typical top-side fan intake, so all the incoming hot air fed straight into the PSU, which did not seem like a wise idea. What was interesting was the noticeable temperature difference in the push to intake scenario since it exposed the radiator with fresh, cool air - however the influx of now warm air increased the power supply temperature. It not being secured and adding pressure to the various cables between it and the GPU seemed suboptimal in terms of component stress and choking of airflow. It turns out that I was able to squeeze in a push/pull configuration, except I was not able to screw in the push fan since it was impeded by the standard 24-pin power cable end. Relative noise level (unmeasured, just by ear) I tested several configurations with the radiator mounting using standard fan curves, all idling at 40C, and here are some crude observations: Configuration
#Assetto corsa pc macbook pro drivers
After successfully booting in, Razer Synapse 3 installed and I updated Nvidia drivers to their latest. To my knowledge, all I have left is to figure out the apple_set_os.efi on an external USB drive or rEFInd with spoof_os_version fixes. I suspect this is from my approach of not using a recommended build/clean install/proper setup, so in order to fire up the eGPU I have to hotplug every time. At this point the laptop hung, with the keyboard and trackpad inoperable.
#Assetto corsa pc macbook pro driver
After sliding the assembly back into the enclosure, I plugged the TB3 cable into my laptop (power switch off), booted into Windows, opened Device Manager, and flipped the power switch.Ī few moments later, the Core X was detected as well as the GPU, and I then installed Nvidia's driver programs and rebooted into Windows. Going with the default push to exhaust configuration, I decided to put the enclosure SUNON fan back in with some tape just for additional circulation (no airflow since the front cover is still in place) since it was a constant lower voltage, low noise fan. After assembling the hybrid kit with the 2080 Ti, I unscrewed and removed the 3-pin enclosure fan to make way for the radiator and PWM EVGA fan that was included.